The Europa Tools Carbide End Mill 2 Flute Square Edge with Long Length and Pulsar DMX coating is built for deep-reach milling in demanding materials. Designed for engineers and machinists who require precise, reliable cuts in pre-hardened steels, this 6 mm end mill delivers clean, accurate results in tight or extended cavities.

• Diameter: 6 mm for controlled material removal and consistent hole and slot dimensions
• Length: 45 mm overall length to reach deep pockets, slots, and extended-cut operations
• Flute count: 2 flutes optimized for efficient chip evacuation and steady cutting in hard alloys
• Edge geometry: Square edge delivers sharp, true-cut profiles and excellent surface finish
• Coating: Pulsar DMX coating enhances dry cutting performance and extends tool life under high-speed conditions
• Substrate: Solid carbide for rigidity, wear resistance, and consistent dimensional stability
• Application: High-speed milling of pre-hardened steels up to HRc55, suitable for dies, molds, and precision components

This end mill excels in deep-reach applications where precision and reliability are non-negotiable. The combination of a long cutting length, two-flute design, and a hard-wearing Pulsar DMX coating helps you maintain tight tolerances, reduce cycle times, and achieve repeatable finishes on tough materials. Whether you’re profiling intricate geometries, pocketing complex cavities, or performing shoulder milling in hardened steels, this tool provides consistent performance and predictable results.