The Europa Tools Pulsar DMX carbide end mill is designed for deep-reach milling in tough materials, delivering precise, reliable cuts where extended reach matters. Ideal for engineers and shops tackling pre-hardened steels and demanding through-cuts.

• Diameter: 10 mm
• Length/Reach: Long-length geometry for deep cavities and extended cutting tasks
• Flutes: 2-flute construction for efficient chip evacuation and rigidity
• Edge Type: Square edge delivering sharp, accurate corners and clean finishing
• Coating: Pulsar coating optimized for dry cutting and extended tool life
• Material: Solid carbide for high rigidity and wear resistance
• Cutting Capability: High-speed performance on pre-hardened steels up to HRc55
• Best Use: Deep-reach milling, pockets, slots, and long through-cuts in tough materials

This end mill is purpose-built to reduce cycle times and improve part accuracy in challenging operations. The long length enables deeper reaches without sacrificing rigidity, while the 2-flute design supports efficient chip clearance at higher speeds. The square edge ensures sharp, true-cut corners, making it well-suited for finishing and pocketing in pre-hardened steels. Pulsar DMX coating enhances dry-cutting efficiency, helping to minimize built-up edge and heat generation, so you can maintain stable feeds and speeds even on demanding materials. Whether you’re machining automotive components, dies, or precision tooling blanks, this tool delivers consistent performance, long life, and dependable results.