The MAKO GLIDE PRO is an evolution of the Mako Glide V2, designed to go even further in terms of fineness, glide, and pumping efficiency.

Significant work has been done on the profile of this new Mako Glide PRO to retain lift and catch while pumping, while adopting a thinner profile, without compromising longitudinal stability .

It therefore retains the Mako Glide DNA:
 easy take-off
 smooth and forgiving pumping
 no unexpected stalls during relaunches or low-speed maneuvers

With less chord and a significantly increased fineness, this evolution allows for a strong reduction in drag and an improvement in overall foil efficiency, while maintaining solid support relative to its surface area.

 Important: the Mako Glide PRO does not generate a nose-down pitching effect at low speed.

The MAKO GLIDE PRO is particularly suited to disciplines focused on performance, glide, and pumping efficiency: lightwind wingfoil and/or freefly, parawing, downwind, dockstart, small-condition surf foil.

The MAKO GLIDE PRO is available in 2 sizes :

• 110: 38 cm wingspan – 110 cm²

• 120: 40 cm wingspan – 120 cm²

 UHM CARBON construction

The construction also evolves, with a stabilizer molded in Ultra High Modulus (UHM) carbon. This layup provides excellent stiffness, despite a very thin profile, and a more precise and more loaded feel than the Mako Glide V2.
This construction, specific to our new 2026 stabilizers, offers one of the highest stiffness-to-thickness ratios on the market 

New feature – 2026 stabilizer range

The 2026 stabilizers integrate a small ramp at the front of the stabilizer, directly molded in, intended for bottom mount setups (under the fuselage).
This detail improves water flow at the stabilizer entry, limits high-speed disturbances, and further optimizes glide.

This evolution is specific to bottom mount setups.
In top mount (Allure, Axis, Cabrinha, etc.), the mounting remains similar to the Mako Glide V2.

IMPORTANT: The Mako Glide & Carve PRO have countersinks for the screws on one side only. It’s up to you to choose the mounting orientation you prefer: BOTTOM MOUNT or TOP MOUNT.

 Important: DO NOT JUMP WITH THE MAKO GLIDE PRO

Compatibility & mounting 

KPARTS stabilizers feature a flat area on one side, allowing mounting under the fuselage (Takuma, AFS, Armstrong, etc.).

The rear slotted hole allows a mounting spacing of 30 to 35 mm, depending on the brand 

Each stabilizer is supplied with:

• a felt protective cover

• a shim set 

• 2 M6 screws

The shim set allows all KPARTS stabilizers to be adapted to your foil, while adjusting the angle to suit your needs.

The adapter shims are produced using 3D printing (PETG).