If you find your current bars were cut too short or designed too short to fit your brake lever and shifter set up, check these out.
Attach these to your bar ends to add 50mm (2") to each side of your bar. Also useful if you want to your cruiser bars to reach back a little farther.

• For city/MTB bars with 22.2mm OD.
• Aluminum construction
• 50mm of extension per unit
• Comes in black or silver
• The resulting fit is not perfectly seamless, but good enough to where it should feel normal after grips are installed.
• DO NOT use on bars that have been partially machined out at the ends (to fit bar end shifters or reverse levers) This includes Soma Oxford, Sparrow and 3-speed II bars
• ID not sized to accept reverse levers or bar end shifters.
• Requires a 6mm hex key (2 inches long) to install