-You will receive a pair ( 2 identical pieces) of blank white wearable resin armor. 

- The pics showing finished armor are just examples of what can be done. I strongly encourage buyers to add their own spin on these designs. 

- These hand guards will arrive flat and should be heat formed to fit the curve of your hand ( see below for heat instructions) 

- The spikes on these are pretty wicked! Dont be a jerk with em!

-Please do not purchase this item if you are unsure of what to do to finish it. I can not personally assist buyers with this project.

- These are RAW CASTS meaning they will need edge clean-up and air bubble filling. They are sent as- is direct from the mold with no sanding or finishing. 

A perfect fit is not guaranteed. You may have to expand the pieces for a better fit. You can do so using heat. 

-Warm the plastic with a hair dryer or on VERY low temp in your home oven ( place on cookie sheet and on a supportive bowl or cookware so the mask does not warp under it's own weight) You can also run it under hot water to soften the plastic as some buyers prefer.

- Only heat for around 5 minutes. 

-Gently pull the sides apart while warm until you get the fit you want. Let the mask cool to set the shape.