Stabilizer designed for surf foiling and wing foiling, with a focus on carving and pumping.

Rest assured: with this stabilizer, you'll carve powerful turns with a foil that pivots effortlessly!

The Mako Carve V2 was developed as a continuation of the V1, offering maximum maneuverability while ensuring control in turns with precise foot placement and a consistent board trim.

We refined the profile to make it thinner, while maintaining excellent low-end performance and stiffness thanks to optimized outline and dihedral.

The result is a stabilizer with increased glide, more efficient pumping, and a very low stall speed.

130: 29.5 cm wingspan

Kparts stabilizers have a flat area on both sides, allowing them to be mounted above the fuselage (AXIS, FONE, CABRINHA, etc.) and below (TAKUMA, AFS, ARMSTRONG, etc.). The rear hole is oblong to allow for a mounting hole spacing of 30 to 35 mm, depending on the brand.

Each stabilizer comes with a carrying case, a set of shims that corresponds to your foil (select from the drop-down menu), and two longer screws.

The shim set allows you to adapt all KPARTS stabilizers to your foil by adjusting the angle to your needs.

Stabilizer machined and manufactured from compressed carbon fibers.

The covers are made of felt.

The adapter shims are 3D printed in PETG.

Note: The bumps are reminiscent of a well-known design (by Laurent Borgna), which inspired the design of this stabilizer.